AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Dual pump sewage ejector system2/11/2024 ![]() ![]() Items Needed For Lid Kit (Sold Separately) are 4 Hex Head Lag Screws ¼” x 1 ½” (minimum), 4 Flat Washers ¼” and 4 Concrete Floor Anchors. Items Included With Lid Kit are 1 Gasket for 4” Sch 40 or SDR 35 PVC inlet line, 1 Gasket for 2” and 3” Sch 40 PVC vent pipe, 1 Gaskets for 2”, 1 ½”, and 1 ¼” Sch 40 PVC pump discharge pipes, 1 Electrical Cord Stopper and 1 1” Adhesive Foam Tape. Sewage Ejector Sump shall be high-density polyethylene and shall be in accordance with ADS installation instructions and those issued by regional, state, or local agencies. Rubber o-rings for these pipes, as well as rubber pump wire plug shall be included in the lid kit. The lid shall be pre-drilled to accept 1¼-inch (32mm), 1½-inch (38mm), 2-inch (50mm) or 3-inch (75mm) vent and discharge pipes. Each well shall have three molded side panels designed to accept an extra inlet line at 90-degree increments around its circumference. The sump well shall have one pre-drilled inlet hole with an o-ring gasket adapter for standard 4-inch (100mm) SDR 35 sewer pipe or a PVC hub for standard 4-inch (100mm) schedule 40 sewer pipe. The Sewage Ejector Sump shall be available in 19-gallon (72 liter) capacity. This specification describes the ADS Sewage Ejector Sump System for use in residential sewage applications. Scope, requirements, material properties and installation with diagrams describe sump. The gravel/stone drainfield is a design that has existed for decades. A conventional septic system is typically installed at a single-family home or small business. Polyethylene is a resilient light-weight material which has excellent chemical resistance. Heavy Duty pits available in set sizes from 250 litre, 700L, 12L. Do not overtighten or the fittings may crack. A conventional decentralized wastewater treatment system consists of a septic tank and a trench or bed subsurface wastewater infiltration system, known as a drainfield. All systems can be supplied with REEFE® Submersible Pumps, Control Systems, Floats and Guide Rail Systems. Once bonded, thread the adapter-end of the PVC pipe onto the sewage ejector pump using a wrench to tighten. Attach the male-threaded adapter to one end of the PVC pipe using the primer and PVC cement. ![]() If you just need to replace an old ejector pump, then you’ll be closer to the average cost but if you’re installing an ejector pump for. This document is the Sump Pump Well Specification. Step 4: Attach Adapter and Pump to Discharge Pipe. The cost to install an ejector pump is 2,500 on average, but you could pay anywhere between 850 to 5,500 depending on the size of the pump you need, the type of pump, and the scope of the project. ![]()
0 Comments
Read More
Leave a Reply. |